top of page
Morris 1000 Front Bumper Valance

Morris 1000 Front Bumper Valance


P+P £30


Domestic Shipping:  Stated postage only applies to mainland UK and does not include Highlands, Offshore Islands, Northern Ireland, Ireland.  If you are in any of these areas please send us your postcode and we will obtain a quote for you.


International Shipping:  We ship worldwide so if you are not from UK please send us your full address including area code and we will obtain a shipping quote for you.


    Application:    This valance is a direct replacement panel for the originals, incorporating the bumper and valance panels.


    Durability:    This valance is made for road use.


    Bolt Holes:    We don’t pre-drill any bolt holes, it is far better to line the panel up and drill the holes where needed, also any holes in the panel make it more fragile and susceptible to damage in transit.  Bolt holes are marked in the panel which can be used as a guide. Tip: drill elongated holes to give room for adjustment when fitting.


    Fitting:    This valance fits flush on the car.  Mark and drill the holes to the corresponding captive nuts on the car, the existing bolts can be re-used if you wish.

    Paint Prep:    Firstly, sand the panel down roughly, then apply primer/filler – a rough sand down will ensure the primer/filler keys well.  Sand down again to a smooth finish and finally apply top coat, either Cellulose or Two Pack can be used.

bottom of page