top of page
Morris 1000 Bootlid Standard, with internal panel + captive nuts, Road Use

Morris 1000 Bootlid Standard, with internal panel + captive nuts, Road Use


Interested in the Morris 1000 Bootlid? Call us now on 07565 109 108 to speak with our friendly advisors and arrange a purchase.


    Application:    This Bootlid fits all Morris 1000 Saloon models, it is a direct replacement panel for the

    original Bootlid.  


    Captive Nuts:    It comes with 6mm captive nuts bonded in at the side for the attachments and 5mm captive nuts at the aperture for the locking mechanism.  


    Durability:    This panel is manufactured for road use with two full layers of matting used for overall strength.  For extra durability, an additional layer of matting is applied on areas for the attachment points or where holes need to drilled.


    Bolt Holes:    We don’t pre-drill any bolt holes, it is far better to line the panel up and drill the holes where needed, also any holes in the panel make it more fragile and susceptible to damage in transit.  Bolt holes are marked in the panel which can be used as a guide. Tip: drill elongated holes to give room for adjustment when fitting.


    Fitting:        Transfer over all existing fitting attachments and fit as per the original Bootlid.

    Paint Prep:    Firstly, sand the panel down roughly, then apply primer/filler – a rough sand down will ensure the primer/filler keys well.  Sand down again to a smooth finish and finally apply top coat, either Cellulose or Two Pack can be used.

bottom of page