MGB Front Valance, Plain

Application:    This valance is a direct replacement panel for the original.  

 

Durability:    All valances are suitable for road use or racing.  An additional layer of matting is applied on areas for the attachment points or where holes need to be drilled.

 

Bolt Holes:    We don’t pre-drill any bolt holes, it is far better to line the panel up and drill the holes where needed, also any holes in the panel make it more fragile and susceptible to damage in transit.  Bolt holes are marked in the panel which can be used as a guide. Tip: drill elongated holes to give room for adjustment when fitting.

 

Fitting:    This valance fits flush on the car.  Mark and drill the holes to the corresponding captive nuts on the car, you can re-use the existing bolts.

 

Paint Prep:    Firstly, sand the panel down roughly, then apply primer/filler – a rough sand down will ensure the primer/filler keys well.  Sand down again to a smooth finish and finally apply top coat, either Cellulose or Two Pack can be used.